Installation with Sensor Net Connect

Requirement Net Device Manager must be installed on a Windows machine: On a physical or virtual, non-dedicated machine Using Windows...

To add a sensor connected to a FoxNet logger in Net Device Manager, follow these instructions Add a new Sensor...

With Magic Config software Download Magic Config connect the Sensor Net Connect on the USB Port of your PC. Press ...

If you use dynamic IP addresses and a DHCP server This is the most common case. You don’t have to...

To set a fixed IP address for a FoxNet Sensor Net Connect or Controller, follow the instructions below Connect the...

Installation Connect the siren to a 230V power supply. Connect the RJ12 cable to a free port on a Sensor...

If you cannot use the Net Device Manager software, you can set up your Sensor Net Connect or FoxNet Controllers...

Welcome and thank you for choosing Sensor Net Connect for monitoring your equipment via SNMP. This guide will walk you...