Before you start
Hardware installation
Follow the steps below to install your FoxNet data loggers. Important: do not install the batteries now. Follow the instructions...
- Home
- Thermotrack Webserve
- Hardware installation
- FoxNet Dataloggers intallation
FoxNet Dataloggers intallation
-
-
Installing Net Device Manager
Hardware installationPrerequisites Net Device Manager must be installed on a Windows machine: On a physical or virtual machine, not dedicated Running... -
Linking a FoxNet recorder to another Controller
Hardware installationIf you want to link a FoxNet recorder to another Controller (e.g. a closer one), you must first disassociate it... -
Add a new FoxNet Sensor in Net Device Manager
Hardware installationTo add a sensor connected to a FoxNet logger in Net Device Manager, follow these instructions Add a new FoxNet... -
Use Thermotrack Webserve without Net Device Manager software
Hardware installationIf you cannot use the Net Device Manager software, you can set up your Sensor Net Connect or FoxNet Controllers... -
Assign a fixed IP address to a Sensor Net Connect or Controller FoxNet
Hardware installationTo set a fixed IP address for a FoxNet Sensor Net Connect or Controller, follow the instructions below Connect the...
