The WeePik datalogger can be used with Thermotrack PC V9 and higher. Important note Do not leave the WeePik in the middle of the reader. You can quickly discharge the battery. Remove it from the reader as soon as you have finished reading or programming. Reading a WeePik Use the…
The WeePik datalogger can be used with Thermotrack PC V9 and higher. Important note Do not leave the WeePik in the middle of the reader. You could quickly discharge the battery. Remove it from the reader as soon as you have finished reading or programming. Programming a WeePik Use the…
Thermotrack-Webserve uses a number of online tools to work. If you are having problems with the display (menus, graphs, etc.), please check that your connection allows you to access the following sites. Copy each of the addresses below into your browser and check that a page is displayed. If not,…
To set a fixed IP address for a FoxNet Sensor Net Connect or Controller, follow the instructions below Connect the Sensor Net Connect or Controller to your PC using the USB cable supplied. Search for the device in the list of devices connected like a USB stick Open the “Config.txt”…
To add a sensor connected to a FoxNet logger in Net Device Manager, follow these instructions Add a new Sensor Net Connect Open Net Device Manager In the “Network Devices” menu, click on “New”. The list of Sensor Net Connect on the network appears as follows Note: If your Sensor…
Error message When programming or reading a Thermo button, you can get such a message : For TBO Link Impossible d’ouvrir le fichier <C:\ProgramData\Proges-Plus\TBO_ Link\xxxx.xx> Détail de l’erreur système : Access denied For TBWeb Link Impossible d’ouvrir le fichier <C:\ProgramData\Proges-Plus\TBWeb_ Link\xxxx.xx> Détail de l’erreur système : Access denied Solution Ask…
Symptom The Thermoscan IP Data Reading Service indicator remains red Data is not being automatically returned Solutions Force the service to start If this is a new installation, it is likely that the Data Reading Service will not be started automatically. To do this, follow the instructions below: Close Thermoscan…
If you use dynamic IP addresses and a DHCP server This is the most common case. You don’t have to set anything up. The Net Connect sensor will automatically take on an IP address and be recognized by Net Device Manager or ThermoscanIP To find the assigned address, use Microchip…
The minimum requirements for the installation and use of Thermoscan IP are Windows 7 and higher 2 GB CPU 80 MB memory for the application 100 MB memory for approx. 1 year of data (depending on the number of sensors and measurement frequency) 1 USB port Internet connection for email…
To replace an existing sensor with another, follow these instructions Open the Net Device Manager software (or Sensor Net Connect software) Delete the existing sensor In the “Sensor Net Connect Sensors” or “FoxNet Sensors” section Locate the sensor by its serial number or by the name of the equipment it…
